Lookah Q7 Mini The latest E-nail dabber for 2022

Introducing the Lookah Q7 Mini, the latest E-nail dabber for 2022 designed for ultimate convenience and enhanced flavor. With a compact size and a powerful 950mAh battery, the Q7 Mini offers 80 to 100 uses on a single charge. Explore the full potential of your sessions with the 710-thread quartz atomizer range, featuring four coil types for a personalized heat and flavor profile. Easily fitting most 14mm to 18mm pipes, this enail is versatile, and a silicon sheath for the downstem ensures compatibility with smaller joint pipes.

Adjust your experience with three voltage settings, ranging from 3.2V to 4.0V, allowing temperature adjustments between 350 to 450 degrees Fahrenheit. Preserving terpenes and flavonoids, the Q7 Mini delivers a flavorful vaping experience. Follow our easy steps to use and clean the Q7 Mini for a hassle-free and enjoyable dabbing experience.

Enhance your dabbing ritual with the Lookah Q7 Mini – the epitome of compact, efficient, and flavorful E-nail technology. Explore the Lookah Q7 manual for comprehensive guidance.

How to Use the Q7 Mini Enail

1. Place the Q7 mini into the downstem of your water pipe. 
2. Open the magnetic flip cap and place a small amount of wax into the center of the atomizer coil. 
3. Close the flip cap
4. Press the power button 5 times within 2 seconds to turn on the Q7 Mini enail. 
5. The device will enter a preheat mode, and the display will show a countdown from 9 to 0 as the preheat is active. 
6. After the preheat has finished, the light will flash 2 times. 
7. Press the power button 2 times to select the voltage mode. 
8. Press and hold the power button for up to 30 seconds to heat the atomizer and vaporize the wax. 
9. Inhale from the mouthpiece of the water pipe. As required, you can adjust the airflow by covering the carb on the flip cap. 

Be sure to wipe around the atomizer to remove any excess wax and turn the device off after you have finished using it. 

How to Clean the Q7 Mini Enail

1. Open the magnetic carb lid
2. Remove the 710 thread atomizer by unscrewing it counterclockwise.
3. Remove the downstem by unscrewing it clockwise.
4. Use the cleaning brush and some isopropyl alcohol to clean the airway between the downstem and atomizer coil. 
5. With some isopropyl and a Q-tip, swab out the area around where the 710 coils would screw into the device.
6. You can swab out the atomizer coil with a Q-tip and some isopropyl alcohol.
7. Clean around the carb cap and the body of the device with a Q-tip and some isopropyl alcohol.
8. When dry, reassemble the parts.